It depends on how your trailer powers its breakaway circuit and whether that power source and circuit work. Changing the house battery to lithium does not, by itself, show that the breakaway brakes will operate; first identify which battery or source feeds the circuit, then check and test the system according to its instructions.
Find the breakaway power source
Check the trailer and breakaway-system documentation for the power arrangement, then trace the installed wiring to identify where the breakaway circuit gets its power. Do not modify the wiring as part of this check. Arrangements can differ, so do not assume the breakaway circuit uses the house battery just because the trailer has one.
- If the circuit draws from the house battery: Replacing that battery changes the battery supplying the breakaway circuit. The relevant check is whether the new source, its connections, and the circuit operate as required.
- If it has a separate battery: The house-battery upgrade does not replace that separate source. Check the separate battery and its connections as well as the system’s operation.
- If the source is unclear: Use the trailer or system documentation and have a qualified service provider identify it rather than guessing from battery type or appearance.
A specific recall illustrates why the actual wiring matters: in certain trailers, the breakaway circuit was powered through the tow vehicle instead of the house batteries, and the brakes would not engage after separation. The remedy routed power from the house batteries. That report describes those affected trailers, not a universal wiring arrangement for travel trailers. The NHTSA recall report documents the defect and remedy.
Verify operation after the upgrade

Inspect the identified source and connections. Check the battery or other source you traced, along with the connections serving the breakaway circuit. A battery label or a match in chemistry does not show that the circuit receives power or engages the brakes.
Use the system’s specified operational test. Follow the test instructions for your trailer or breakaway-brake system; test steps and conditions are system-specific, so do not substitute an assumed universal procedure. A battery change and a wiring example from another trailer are not proof that your system passes.
If the prescribed test does not confirm that the breakaway brakes operate, do not tow the trailer. Have the power source, wiring, switch, and brakes diagnosed and repaired as needed, then repeat the applicable test and confirm operation before towing.





